I can't figure out how to create a 1st floor that has an opening in it because whenever I draw walls an Auto Floor is created (Auto Ceiling is also created). I have a Ground floor and a 1st floor. The 1st floor has a large opening in it but when I draw with the Floor Opening tool the Auto Floor hides the opening. This is very confusing. I would like to be able to draw my walls and floor separately but can't find a way.
2 posts • Page 1 of 1
- New member
- Posts: 2
- Joined: April 1st, 2018, 12:36 pm
- Posts: 69
- Joined: December 22nd, 2017, 4:10 am
Hi. Just remember that "floor opening tool" is in fact a "ceiling opening tool". If you want to make a hole in floor of the 1st floor, you have to go to the ground floor in the inspector and make a hole in the ceiling. You always make holes "upwards", not "downwards".
Who is online
Users browsing this forum: No registered users and 3 guests