
Straight walls
-
- Member
- Posts: 11
- Joined: October 13th, 2014, 5:00 pm
Straight walls
Hi, I only use the program to produce 2d plans and it is great. There is one thing however that is a total pain. Is there any way to draw a directly straight wall? Sometimes when I am trying to draw the wall straight even if it is snapped to being straight once it get near another wall it will create a very slight angle. This is very frustrating because I want my wall straight not at an angle. I have tried holding down shift whilst drawing a straight wall but this has no effect. Kind of like in Photoshop if I want to draw a straight line with a tool then I hold down shift when I draw and the line is perfectly straight to a multiple of 45 degrees. Is there any way of doing this? 

-
- New member
- Posts: 3
- Joined: December 11th, 2017, 11:26 am
Re: Straight walls
I totally agree! This would be a very useful feature to add to the program.
-
- Member
- Posts: 7241
- Joined: July 6th, 2006, 3:13 am
- Location: Odessa, Ukraine
- Contact:
Re: Straight walls
Hi,
You can draw a wall holding down the Shift key. In this case, the wall will snap to selected angles: 0, 15, 30, 45 degrees and so on.
Also, you can turn off any snapping using this menu command: View > Disable 2D View Snapping,
or hold down the Cmd key while you are moving around a wall end. Control the wall angle using the Info bar which is right below the tool bar.
Nick
You can draw a wall holding down the Shift key. In this case, the wall will snap to selected angles: 0, 15, 30, 45 degrees and so on.
Also, you can turn off any snapping using this menu command: View > Disable 2D View Snapping,
or hold down the Cmd key while you are moving around a wall end. Control the wall angle using the Info bar which is right below the tool bar.
Nick
Who is online
Users browsing this forum: No registered users and 2 guests