Page 1 of 1

Posted: February 21st, 2012, 3:32 pm
by brandon
are there island cabinets and corner cabinets (both base and wall) in the library? I tried to use a base cabinet and change the width to make it into an island but all of the other dimensions changed with it.


Posted: February 22nd, 2012, 9:28 am
by Nick
Hi brandon,

I haven't found any corner cabinet in the library.

To change only one object dimension, deselect the Maintain Aspect Ratio check box in the Inspector.


Posted: February 22nd, 2012, 10:19 am
by Anthony
Brandon, Hi

To create an island, select base units to the length you require & then select & rotate base units to for the rear of the island, you can change the depth of the units if necessary
Also use ' Shape ' material as work surface to cover the library work surface if required

'Shape ' will also allow you to create end panels & plinth and flat slab doors

Hope this helps


Re: Kitchen Cabinets

Posted: January 17th, 2018, 2:13 am
by charlieadison
I didn't find a corner cabinet in the library. But, I suggest you to take an expert's advice. Or there are many websites available on the internet from where you can get the best idea.

Kitchen Cabinet Painting Oceanside CA