I am trying to print BookPlates (many of them), and some of the dedications are quite long while others are short. I designated a custom field for the text inside of an image. Of course, the lines are too long.
After searching the forum, I noticed that there was an AutoResize in the print dialog. However, even when I select this - the text does not change.
Can I get some help with this?
2 posts • Page 1 of 1
- Posts: 7237
- Joined: July 6th, 2006, 3:13 am
- Location: Odessa, Ukraine
Who is online
Users browsing this forum: No registered users and 4 guests