Page 1 of 1

EVOLIS Zenith ID Badge Printer Issue

Posted: June 9th, 2015, 7:03 am
by STBQP
I am attempting to print to an EVOLIS ID printer. I originally had selected the wrong printer so it was attempting ten prints per page (A4). When I selected to only print to the "5" card it printed me one half of the image. I realized that the printer was calibrating the card to the center of the page. I have now selected the proper paper type (EVOLIS) and when I print it simply lays blank film onto the card. I am afraid that it may still be thinking in terms of an image centered on A4 even though the stated print dimensions are accurate. Does anybody have an idea how to troubleshoot this issue?

Re: EVOLIS Zenith ID Badge Printer Issue

Posted: June 9th, 2015, 7:05 am
by STBQP
Also, in the print preview it shows a full A4 page with my design in the upper right hand corner.

Re: EVOLIS Zenith ID Badge Printer Issue

Posted: June 12th, 2015, 5:01 am
by Ajax
Do you see proper preview when you set Evolis layout to be printed?