calibration problems artisan 725

slane18
New member
Posts: 3
Joined: November 23rd, 2011, 6:00 am

Postby slane18 » November 23rd, 2011, 6:08 am

I have read the posts on calibration problems and have tried to act accordingly. I am having problems with getting my image to go to the top of the dvd. I set the calibration to - vertical 15 at first and it was better placed than my first attempt at 0. Then tried - vertical 25 and the image was lower than - 15 for some reason. Then tried - vertical 30 and the image was even lower than -25.

Whats up with the numbers man?
Last edited by slane18 on November 23rd, 2011, 6:09 am, edited 1 time in total.
Nick
Member
Posts: 7241
Joined: July 6th, 2006, 3:13 am
Location: Odessa, Ukraine
Contact:

Postby Nick » November 23rd, 2011, 8:15 am

Hi slane18,

You don't need to guess the calibration values. Input what the printed rulers indicate crossing the label or disc cover edge. Note that there are positive as well as negative values on the rulers.

Then print your design (not the calibration sheet).

Nick

Return to “Disc Cover”

Who is online

Users browsing this forum: No registered users and 2 guests