Page 1 of 1

A frame home

Posted: December 16th, 2017, 5:19 pm
by huckone
Hello, I'm new to this forum and new to this software and I have a general question with the SW capability. I have an A-frame home with 24:12 roof pitch. The home has a a walkout basement, where the 8' walls are vertical, like a normal home. The main floor, however, has angled walls (i.e. the roof). The second story is a loft and also has angled walls, this loft overlooks the main level. Does this software support modeling this type of home configuration? I would like to model my home, because I'm looking to add a front entry addition to it. I was also wanting to do room layouts etc. for the interior. Thanks in advance for any input on this.

Re: A frame home

Posted: December 17th, 2017, 1:54 pm
by amingermany
I'm not sure if this post will help you. You can check and see.
viewtopic.php?f=50&t=46848

Re: A frame home

Posted: December 19th, 2017, 5:38 am
by Nick
Hi

Here is another example of a roof that might look like yours:
https://www.belightsoft.com/forum/viewtopic.php?f=50&t=9108
Scroll this discussion to the middle, right below a post with question marks instead of text.

Nick

Re: A frame home

Posted: December 24th, 2017, 5:59 pm
by huckone
Hey I appreciate the responses. I will check out the posts mentioned for additional info. Holidays might slow me down tho'.