Does not adhere to form specs for Avery 8162

New member
Posts: 2
Joined: January 17th, 2010, 12:42 pm

Postby joecain » January 17th, 2010, 6:25 pm

I received the following email, but clicking on the url does not work.
I am also unable to locate the response, or even my own post since the system says I have never posted! I had subscribed to topic but the system says I have no such ..
Sent: Sunday, January 17, 2010 2:20:20 PM GMT -05:00 US/Canada Eastern
Nick has replied to the topic 'Does not adhere to form specs for Avery 8162' to which you are subscribed.

The post is located at
My post was that printing on Avery 8162 ignores the setting that drops the first label about 22 mm from the top, and instead prints as if there was no drop down.
Posts: 7241
Joined: July 6th, 2006, 3:13 am
Location: Odessa, Ukraine

Postby Nick » January 18th, 2010, 8:34 am

Hi joecain,

If all printed labels are too high on paper, you should run printer calibration (File > Calibrate Printer. You print the calibration sheet on Avery 8162, find out the offset distance using the printed rulers and input this value into the calibration dialog.

Note that:
1. You should select Avery 8162 before starting calibration.
2. The calibration rulers take several labels on the page. To utilize the rest, set "Start from label" to 3 in the print dialog when you print your labels next time.


Return to “Labels & Addresses / Mail Factory”

Who is online

Users browsing this forum: No registered users and 1 guest