3 posts • Page 1 of 1
I'm using Avery 5160 labels and I can't get it to fit vertically. I used the vertical alignment numbers and to no avail. I've even tweaked above what the tick marks show and it just stays the same.
I kind of solved my own problem. When I use the regular white label it prints fine and when I use the invisible label that's the one that prints off. Must be in the way the printer is feeding the invisible sheets.
The calibration settings do not affect the calibration sheet. the Marks on it which show the offset never go to the zero point after successful calibration. Contrary, a regular document should consider the calibration values while it is printed.
Who is online
Users browsing this forum: No registered users and 3 guests