Page 1 of 1

Unable to change dimensions in mm in 3.1.1

Posted: February 6th, 2016, 10:14 am
by timothevs
Crazy how 3.1.1 broke things. I had it working perfectly fine in 3.1, but now in 3.1.1 if I change the units to mm, and try ot change the same for the layout of the disc, it won't allow me to. Only after changing it back to inches can I make any changes.

I am not sure if anyone from Belight is checking this forum anymore, but if anyone is, PLEASE HELP!

Re: Unable to change dimensions in mm in 3.1.1

Posted: February 8th, 2016, 9:23 am
by Nick
Hi

I can see that it is impossible to change values in the Outer Diameter edit box in Inspector > Design Element tab > Sizes section when the measurement unit is not inches. Steppers work. Did you mean this or some other problem?

Nick