Page 1 of 1

CD labels

Posted: October 14th, 2014, 8:16 pm
by Dead End King
How do I select a disc size that goes right to the actual size of the hole? The inkjet printable CDs are printable over the area around the hole which is often translucent, and all the disc size templates I try seem to not factor in the translucent part, if that makes sense.

Re: CD labels

Posted: October 15th, 2014, 2:46 am
by Nick
You can change the Inner Diameter in the Design Element tab of the Inspector. In the Presets popup menu, there are two predefined options: default and Full Coverage. Or, you can create a custom layout using File > Custom Paper/Tray, and then select it for your document.


Re: CD labels

Posted: October 15th, 2014, 11:02 am
by Dead End King
Awesome, it worked out, thank you very much :)